As of 06.08.21 all MK84 Kits are in stock and ready to build and ship. NOTE- If you order with Radflo rear shocks, Radflo is a 12 week wait time
Fits 2005 to Current Frontier
This is a complete 3" front and rear suspension lift for your Frontier.
MK 84 front coilovers are fully adjustable from 0.5-2.5" of lift coupled
with our 1" top plate spacer allows up to 3.5" of front lift to be run (best ride quality is 3" of front lift or below)
Included in Kit (choose in the drop downs below for more options):
Nisstec MK84 series 2.0 coilovers-
ALL NEW We replaced the lower heims with rubber bushings. Perfect for all weather conditions, helps soak up more road vibrations, and no unwanted noises.
- 5/8” Nitro Steel shock shaft offering better corrosion resistance than chrome plating
- Valved to your Nissan for improved on and off-road performance and handling
- Clear-Blue Chromate zinc plated steel shock bodies
- Adjustable from 0-2.5” of lift height. We recommend them to be run from 0-2” for best shock travel.
- 200psi nitro charged and all shocks are dyno tested prior to shipping
with Eibach Springs, the best name in springs. Available in 50 lb.
increments from 500lb to 700lb to suit your vehicles aftermarket weight
- Fully assembled and ready to bolt-on with T-6 aluminum anodized top mounts.
- Priced as a pair
- Comes with a spanner wrench for adjusting lift height.
- 100% Made in the U.S.A.!
We recommend the following spring rates for your Nissan
lb. springs- Great for 2wd stock front weight Xterra’s and 2wd- 2 door
and extra cab Frontier’s. Also work great for a plush ride on 4x4
Xterra’s with no front weight
-550 lb. springs- All stock weight 4x4 Xterra’s and Frontier’s. Good for 2wd models with skids, sliders, and tube bumpers.
-600 lb. springs- All models with plate front bumpers, lighter 8000lb winch W/syn line, skids, and sliders
-650 lb. springs- All models with plate bumpers, all of the above with some extra weight
-700 lb. springs- Only for heavy oversized bumpers, heavy 12000 lb. winch W/steel cable, heavy skids, heavy
Please Call If You Are Unsure What Spring Rate To Select.
- (2) Extended travel SPC upper control arms
- (1) Spanner wrench for coil over adjustment
- (2) NissTec rear 2” lift Add-A-Leafs w/ hardware- This custom longer
rear AAL provides a great ride on and off-road, all while adding the
ability to carry some extra weight on the back of your Frontier
Old Man Emu CS150R Med Duty Leaf Springs
Old Man Emu CS151R HD Leaf Springs (For use with 400+ LB consistent rear weight installed on the back or bed of your truck)
- (2) Nisstec 1" Rear Lift Block Kit
- (2) Front braided stainless longer brake lines
- (2) Rear braided stainless longer brake lines
- (4) New Longer zinc plated rear Ubolts
- (2) Bilstein 5100 series nitrogen charged rear shocks (Comes Standard)
- (2) Radflo Emulsion 2.0" or 2.5" Remote Res rear shocks.
*Fronter Coilover notes:
preset all Radflo coilovers at about 2" of front lift height with our
1" top plate spacer already installed. These presets are based off a
brand new stock weight 4x4 Frontier. If you own a 2wd Frontier or have a
heavy front bumper and/or winch installed, you may have to raise the
coilovers or lower them. Please see the last page of our install
instructions for more info on how to adjust your coilovers. Once your
kits is fully installed and you have driven your Xterra around a block
or two. We highly recommend parking on level ground and measuring your
front end. Measure from the center of your hub (wheel) straight up to
the bottom lip of the fender. If this measurement is greater than 23",
you must lower your coilover!! Running your coilovers too high will
cause premature shock failure and will void your warranty. Plus they
will ride poorly
* Rear Lift Option notes:
** Please note If shipping OME leaf springs to Hawaii or
Alaska, we will contact you to confirm any additional shipping charges
We also offer custom built to order rear Alcan or Deaver leaf packs. Please call or email us for pricing
If your vehicle does not have adjustable cam bolts installed, you WILL NEED THEM!! Nissan only installed adjustable cam bolts in some 2005 year Froniters. Cam Bolts allow +/- 2 degrees camber/caster adjustment and are a must with this kit for proper alignment!!
All Radflo shocks are custom built to order. Please expect 3-8 weeks for your new AWESOME race shocks!